2000 Toyota Tundra Catalytic Converter Monitor Does Not Work

Went to Autozone and it is the bank 2 passenger side catalytic converter code P0430.

2000 toyota tundra catalytic converter monitor does not work. The converter can also overheat and break apart inside becoming restricted or plugged. Make Sure the Engine Light is Off. A worn-out oxygen sensor can cause engine performance problems and shorten the life of the catalytic converter.

This can go on and on and onso basically because the system did not fail it twice it. Reg cabIve been to the tester 4 timeit wont make it thru emissions cause the CATALYST monitor wont get ready. Toyota Tundra 2000 Premium Oxygen Sensor by Bosch.

In case you need to replace this part just check out our selection of Toyota Tundra catalytic converters components. Discussion in 2nd Gen Tundras 2007-2013 started by Tundra196 Mar 4 2020. Hold a steady speed of 88kmhr 55mph for five minutes.

But if you have to face a fully plugged catalytic keep driving your car is the thing you have to avoid. Accelerate at 34 throttle until 88-96 kmhr 55-60mph. During this time in addition to the diagnostics performed in step 4 the catalyst monitor diagnostics will be performed.

Too much unburned fuel can coat the catalyst causing the converter to stop working. I have a 2008 Tundra CrewMax Limited with 180000 miles. Sensor 1 is before the converter Sensor 2 is behind the converter Bank 1 and 2 are typically used in V-configuration where Bank 1 is on the side Cylinder 1 is located.

The DAD ois is the new system for cars 2000 and newer it plugs directly into the obd port and looks at the vehicles computer data. It is NOT until the SECOND failure that a code will set. So for the past month and a half after the fail smog check the Tundra has been driven about 1000 miles with the catalyst monitor still incomplete and all other monitors completed.