2000 Toyota Tundra Drive Cycle Catalyst

These Monitors are part of the OBDII protocol so that the car can be warmed up and driven to see all of the smog.

2000 toyota tundra drive cycle catalyst. Driving Procedure If IAT is less than 50E F 10EC at engine start-up idle engine for 10 minutes. It takes a bit of work to find - that is indeed the guide I used To summarize. Sounds like your.

Each diagnostic check communicates with a monitor called a readiness monitor. Otherwise you need to exercise each of the types of monitors. I put new oxygen sensors both the front O2 and and rear O2.

Drive Cycle Information OBD Readiness Your vehicle performs up to 11 diagnostic checks of specific emission control components such as engine transmission fuel systems and other emissions controls. If there are pending malfunctions that have not yet turned on the malfunction light the monitors will not become ready. All models 1996-2002.

EGR MONITOR DRIVE CYCLE. If you feel you will not be able to complete the driving pattern safely please seek assistance from a Toyota dealership. 65mph for 12 hr and 30-45 mph for another half hour.

The OBDII drive cycle begins with a cold start coolant temperature below 122 degrees F and the coolant and air temperature sensors within 11. 2000 Toyota Tundra. Discussion Starter 1 Apr 21 2014 Edited Hello I have a 2000 SR5 w47.

The dealer will be able to perform the drive cycle on a dynamometer. You must park the vehicle in a heated garage above 40 F for 12 hours with the key off and fuel tank at 12 to run the evap monitor. Thanks to Steve for posting the link to the Toyota monitor drive patterns.