2000 Toyota Tundra Drive Cycle

If your smog technician tells you the specific drive cycle to perform you can focus on just triggering that drive cycle.

2000 toyota tundra drive cycle. The drive cycle should be performed after you have erased any trouble codes from the PCM memory or after the battery has been disconnected. These Monitors are part of the OBDII protocol so that the car can be warmed up and driven to see all of the smog stuff is working. Ive only drove in D2 with the RPM at around 3000 once.

Its possible that more tan one monitor may run while doing a particular drive trace but heres the official procedure from ToyotaLexus. IAT Intake Air Temperature must be above 13E F -10E C. Make sure the ambient temperature is between 40 and 95F.

The average cost for a Toyota Tundra OBDII drive cycle test is between 44 and 56. No vehicle owner needs to be involved with that. The OBDII drive cycle begins with a cold start coolant temperature below 122 degrees F and the coolant and air.

There are several Monitors that need to be set. I have a 2000 Toyota Tundra V6 Base Model that wont pass smog in California I have replaced the Up and Downstream O2 Sensors but still get the notice on my ODB2 Scanner that the Catalyst and the Evaporative systems have yet to report any data and that is what is causing the SMOG check to fail. There is also a lot more that goes into choosing the right car for you so keep reading to find.

The diagnostic codes that are required by law on all OBDII systems are generic in the sense that all vehicle manufacturers use the same common code list and the same 16-pin diagnostic connector. 1996 to 2002 Toyota OBD II Monitor Readiness Drive Patterns. Thus a P0302 misfire code on a Nissan means the same thing on a Honda Toyota.

Estimate does not include taxes and fees. Instructons to set the drive cycle for 2000 toyota tundra Customer Question. Make sure the vehicle has been parked with the engine off for 6 hours or more.