2000 Toyota Tundra Starter Relay Removal

Disconnect all the bolts that hold the starter to the block using a ratchet.

2000 toyota tundra starter relay removal. When I turn on the ignition all gauges function but the starter does not. 2000 Toyota Tundra starts occassionally. Remove the positive cable the large cable that runs to the battery from the starter.

If the radiator is still warm allow it to cool off before you start next step. On the battery or the starter a bad battery or a bad starter. Please Read In this video I show you how to remove a starter from a 3rd Gen 4runner 4x4 repair the solenoid and reinstall it.

1 disconnect battery 2 remove any wires connected to the starter 3 remove mounting bolts 4 catch the starter and manouver it through your suspincion 5 you may need to reverse 2 and 3 depending on how hard the wires are to get to 6 now revers these steps with new starter. I am not responsible for any damages that occur upon watching this video. Remove the starter and power and signal leads replace with new or quality remanufactured installation is reverse procedure of removal.

2000 Toyota Tundra starts occassionally. Heres a bypass for those that dont have the starter relay on the wheel well. 15 hours to remove and 45 minutes to replace.

The removal of the start. Posted by Anonymous on Jun 24 2014. 2000 Tundra AC SR5 47 V8 4WD 32000ish miles.

Lift the relay required me to use a screwdriver to get under the relay and pry it upwards from different angles until it got loose enough to be pulled up by hand. Was the Starter Relay inside the engine fuse box and not the Starter of Starter Selinoid. Starter clicking but not turning over can only be caused by bad battery terminals.